The Watch Stand – Compatible with Withings ScanWatch Nova

The Watch Stand – Compatible with Withings ScanWatch Nova

The Watch Stand is a 3-part 3D printable stand compatible with Withings ScanWatch Nova. The stand consists of a base plate with extra slots for rubber feet or pads, a support stem, and a charger holder for the original watch charger.

Print settings

• Recommended materials: PETG, PC, ASA, or ABS.

• Recommended infill: at least 25 %.

• Supports are recommended, especially for the charger holder and stem.

Assembly

• Press all parts firmly into place until they are fully seated, as shown in the photos.

• The fit between the base plate and the support stem is intentionally tight. Press the stem all the way down into the base plate. The opening in the bottom of the base plate allows you to check tight. Press the stem all the way down into the base plate. that the stem is fully seated.

• The cable holder is designed for a cable diameter up to 2.5 mm.

• Once the stand is fully assembled, attach the original charger securely to the charger holder.

Disclaimer

This is an independent 3D printable accessory and is not affiliated with, endorsed by, or sponsored by Withings.

Note

The same version of this model is also available on Thingiverse. For documentation, printing instructions, updates, and the changelog, visit: https://www.thingiverse.com/thing:7375122

License

Creative Commons Attribution-ShareAlike 4.0 International (CC BY-SA 4.0)

You are free to:

• Share — copy and redistribute the model in any medium or format

• Adapt — remix, transform, and build upon the model

• Use commercially

Under the following terms:

• Attribution — You must give appropriate credit to the original author

• ShareAlike — If you modify the model, you must distribute your contributions under the same license

This model is provided as-is, without warranty. Use at your own risk.