1 / 9
Bucket, Teeth, and Sides for Professor Boots Wheel Loader — zdjęcie 1
1 / 9

Bucket, Teeth, and Sides for Professor Boots Wheel Loader

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Beefed up and more detailed version of Professor Boots bucket with removable teeth and sides.

Ocena
0 / 5
Polubienia
6
Pobrania
54
Wydruki
0
Wyświetlenia
232
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Edit: 6/28/26. Uploaded some photos for clarity. Description about those photos added below.

You MUST use thick bridges for everything to work.

You MUST turn supports off for everything.

I have uploaded both STL and 3mf files. I highly recommend you use the 3mf file and just print with PLA. You can try the STL's but I went through a lot of tinkering to get this right as much as possible.

Built in supports should be easy to remove if you heed the following --→ Please please PLEASE make sure the models in question are split into objects (not parts). You should be able to click on each object and it highlights separately. If you fail to do this. The custom supports will become one with the bucket, teeth, and side pieces. You will not be able to remove the supports.

You may see a warning from your slicer about things floating. This is normal if it all works so just ignore that. If you are wondering why the support for the bucket has the arm in the middle. It's because the slicer needs some sort of 3D reference point down to the same plain as the bucket itself. Without this. The support would sink through the bucket.

You may remove the supports and use slicer generated supports or if your bridging is set right. You may not need supports. But I've included them for any user who wants them.

The big support for the bucket portion should print as a separate object and should leave minimal scaring. It'll print an overhang line but .2mm higher so it shouldn't “press” itself into the bucket surface. The thicker bridge setting makes this happen. So it'll contact the base and sides of the bucket but only a little. Just enough to not move but enough to offer the support needed.

I made the custom supports because, at the time, I was not familiar with this concept. So my pic shows a lot of scaring due to using slicer generated supports and there is a bug within Orcaslicer V2.3.2 where that base pattern spacing is following the top pattern spacing. Didn't know this tell after the fact. This made it stick way too much to the base of the bucket when I went to remove the support. Took an hour and a lot of cussing to get it out.

Edit 6/28/26. The teeth on the edges...It'll be a little tricky to get that heat insert in. But it is possible. Just be patient and let the solder iron do the work by heating it up enough to melt through the hole. If you mess up a bit and tough the solder iron to the PLA in that area. The side piece will most likely cover this up.

Note that I only included the left and right tooth once. You'll need to duplicate those for three times each side if that wasn't clear already. Make sure you duplicate their custom supports as well and that they are split by object. If you print them without splitting them by object. They will fuse together. It may still be possible to get the custom support off but it may be messy and this can be avoided by splitting by object (not parts).

Tagi