Pick and Place Bottom Camera
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Thought I would share my bottom camera mount for my PNP machine. It uses the standard USB camera that is common to…
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 739
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Thought I would share my bottom camera mount for my PNP machine.
It uses the standard USB camera that is common to Open PNP. I use 30mm 3mm x .5 bolts that self tap to the bottom arms. A nut is installed and locked in place to allow the bolt to be adjusted and raise and lower the corners. This allows for perfect leveling of the sensor. When printing the bottom you can stop the print if you don't need it as long as designed depending on the lense you use.
Pictures should be self explanatory.
The led PCB board was created to fit the 20 degree slope of the top part of the mount allowing the light to focus a little above the top lip. It was a toner transfer to flexible pcb board.
Hope it's useful or gives you a good idea.
Cheers
Kisssys
Category: Electronics