Saddlebag mount for a Garmin Varia (extra secure)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I added a slot under the Garmin mount plate for a wire tie around the whole thing to make it extra secure.
- Ocena
- 5 / 5
- Polubienia
- 31
- Pobrania
- 345
- Wydruki
- 4
- Wyświetlenia
- 2178
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
A mount for a Garmin Varia radar to a saddle bag. I added a slot under the Garmin mount plate for a wire tie around the whole thing to make it extra secure. The downside is that you need longer screws than the ones that come with the unit. You need M3 screws, 8 mm long. The slot is 1 mm x 2.5 mm sized for a small wire tie.
Printing:
The best orientation for printing would be on its side to make sure there are no layer joints that would make the two halves of the mount easily separate. But the sides are not flat, so I printed it with the top (edge where to two sides join) down and used supports.
PETG for use outside with 60% infill for strength.
Used a .4 mm nozzle with a .2 mm layer height.