30mm Watercooling Radiator (Proof of Concept)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An experiment in the properties of 3D printing resin, in the form of a watercooling radiator with a small internal…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 466
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
An experiment in the properties of 3D printing resin, in the form of a watercooling radiator with a small internal reservoir, designed to fit a 30MM computer fan.
A cutaway model has also been provided so you can observe the fluid paths.
The radiator has also been filled with red food coloring to, again, show the internal fluid path.
It probably won't actually work as a radiator, but...
I primarily designed this as an experiment to research:
-Designing internal fluid paths
-How pipe threads work in resin (This aspect failed in a previous prototype and was just replaced with built-in barb fittings)
-If resin can indefinitely handle water, or even handle compressed air or steam
-How much pressure and temperature resin will take
-If resin it can actually transfer heat effectively AT ALL
Any many other aspects and properties.
Keep in mind. I'm NOT intending on using this as an actual cooling system component, and NEITHER SHOULD YOU. I'm not responsible for how you decide to use this thing.
It's merely a proof of concept, and a test part for discovering and studying the properties of 3D printing resin for future practical uses.
Print Settings
Printer Brand:
Anycubic
Printer:
Photon
Rafts:
No
Supports:
Yes
Resolution:
0.05
Infill:
Solid
Filament: Anycubic UV Resin Clear
Notes:
Do not print this part hollow. The internal cavities have already been made, and additional hollowing is not needed.
This is something I really wouldn't do on FDM, due to lack of watertightness, hollow fluid paths making supports a problem, and the flexibility and low deformation temperatures of the plastic making it entirely impractical for anything involving fluid pressure or high temperatures.For best results, print the model on its back, with the fan mount facing down/away from the build plate.
I noticed some weird distortion the farther away I got from the plate, but that might just be down to my settings, I just got my Photon and I'm still getting it tuned in.
Category: DIY