MGN9H to MGN12H adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapts a MGN9H linear rail mount to MGN12H
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 59
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Print Settings
Choose a filament that meets the temperature and strength needs of the adapter. I chose ASA GF.
Infill: 40% Adaptive Cubic. This is not critical and is somewhat dependent on the application.
It is recommended to use 100% infill around the M3 bolt holes. It is not critical, but gives the bolts a firmer surface to mount against.
Wall: 5 lines
Adapter Installation
Parts Required:
Assembly Instructions:
Tighten the adapter to the linear rail by inserting the tightening the M3x8 bolts.
M3 T-Nuts are slid in over the M3 x 6 bolts to fasten an MGN12H attachment to the linear rail.
Attach the MGN12H component
Belt Attachment Installation
Parts Required:
Assembly Instructions:
Install the heat set inserts in to the 2 holes on the side of the adapter
Fasten the belt to the front of the belt attachment
for the 2 attachments points in the back, wrap the belt around an M3 screw and fold the belt on itself.
Note: I am an Amazon Affiliate and may make a commission from products purchased from the links in this post.