Longboard Mud Guards
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed around Backfire G3 Trucks
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 424
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
!! WORK IN PROGRESS !!
Designed to fit over the front trucks on a Backfire G3 Board. I am still working on guards for the back.
I have printed V3 of this which is identical with the exception of the chamfers on the center hole. My guards snapped at the truck connection after 1 mile, but the road was all chip-seal, so very rough. Only extra hardware needed is one additional spacer to go between the truck-side spacer and the bearing, and I added a single layer of electrical tape around the truck to make more friction. The truck-side spacer gets pressed into the guard then the extra spacer, wheel, spacer then nut.
Filament: Overture Space Grey PLA
Infill: 15% with three top and bottom layers and 3 walls.
Supports: Oriented so only the part that goes over the truck needs them.