Pen F (Film) Mount Body Cap (Various Styles)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Models for a Olympus Pen F film camera mount body cap
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Here are 3 different versions of the body cap for the Olympus Pen film camera line! There is also a digital camera with the same name but if you knew that already I'm sorry for writing the word film everywhere you can ignore that :). I've made a version with an inset F script logo as well as one with a debossed logo for those of you who just want it a little more simple looking, and if you want it even more simple I have added a version with no logo at all. .stl or .3mf depending on what you want to do I'm not sure if theres any point in adding the .3mf of the non-multicolor prints but I did it anyway.
The prints shown were made on my BambuLab P1S with a .4mm nozzle with .2mm layer heights using white SUNLU PETG and BambuLab Matte Dark Blue PLA (I am aware that PETG and PLA don't play nice together, but they did stick well enough to not fall apart). if you wish to print this yourself you can use a smaller layer height but I have NOT tested the strength of the plastic that gets locked into the mount at smaller layer heights.
Notes about printing/slicing:
Make sure to use a darker filament or use an infill pattern/density that would block more light from reaching inside the body if there is a light meter that may drain your camera's battery (Ex. Cubic or Cross Zag infill patterns). I didn't follow this advice on my print in the images and my light meter was reading when pointing the camera at a bright enough light source.
I recommend printing with the logo/flat side facing down on the build plate for better adhesion + print first layer slow or use a brim (I did not have to use a brim for this model when printing as compared to my other body cap designs but it would help if you're having issues with adhesion).
Make sure there are no stringing bits on the top part that will go inside the camera to avoid getting anything on the sensor/mirror.
I don't recommend using tree supports for this just because pulling traditional supports out of the mount was just much easier for me.