Anthead OrbiterV2 V2.5 LDO NH36 Rigid Mount

I designed this mount to rigid mount the NH36 THB to both the Orbiter v2/2.5 and the Micron Anthead carriage. Just didn't like the floating THB on the motor by itself, since the cable is very happy to flop it around. Also, 4 screws must be better than 2? Idk.

It however needs a printed spacer which I also included. 

Some features

• Chamfers! one messed up chamfer as well! 

• Aligned speed hole for extruder motor for no reason? 

• Still easy to remove the extruder for servicing - Take off the 2 screws for extruder mounts and 2 screws that mount the board to the stand-off and away you go. Holes are slightly undersize so they stay in place when you do so. 

• Do have place for zip tie (but not support the toolhead cable) - check below

• EDIT:

  • UPDATED to the fixed version with now more corrected location for screw holes. 

  • about 1.6mm thinner - doesn't seem to impact my IS or stiffness of the mount very much.

  • Now have toolhead cable support and relocate the ziptie mount so it's fully funtional now

  • Not sure why it has non-manifolded edges... so you gonna have to press "Fix Model"

BOMs:

• 2x 6mm m3 screws for the top-left and mid-left screw holes.

• 2x 8/10mm m3 screws for the bottom 2 screw holes.

• 1x longish, 12mm+ m3 screws the the last mid-right screw hole.

• 1x voron heatset insert for the mid-left screw holes.

Print settings:

• I stick with voron setting if you want a flat looking piece that also very rigid

• alternatively, voron setting but:

  • 2 walls/perimeters.

  • alternate extra wall.

  • 80% infill triangle 2 multi-lines.

  • no bottom and top layer.

  • 1 perimeter on top and bottom layer - off.

  • this version should be just as stiff but even better, saved about 1.1g if you're into that.

  • also looks cool and you would never see it, so, oh well.

Let me know if anything broken or whatsoever. I am measuring this based on actual part and CAD, printed in BBL ABS-GF and Fusrock ABS-GF with no shrinkage applied.