1 / 4
AntHead body for Dragon ACE and fan spacer — zdjęcie 1
1 / 4

AntHead body for Dragon ACE and fan spacer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

AntHead body for the Dragon ACE

Ocena
0 / 5
Polubienia
2
Pobrania
6
Wydruki
0
Wyświetlenia
154
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I redesigned the Anthead hotend mount for the Dragon ACE. Great litte banned hotend that also have a respectable meltzone that fits in Standard Flow toolhead for the most compactness. But oh well, the clogs and the fan placement of the stock mount are not favourable for this hotend. 

BUT, YMMV, I am not an engineer! But also, it should works with other hotends as well in the same set up, but I wouldn't have them to test. 

Some features

  • Move the hotend fan up about 2.6mm to more or less directly blow onto the heatsink and the cold side. This is as much as possbible without changing the stock body. Fan will butt up against the cover, all good.

  • Widen the fan duct to 23.5mm - I use an RC 5V fan in the photo but other will work just fine with this.

  • Completely open up the fan duct so no air blowing onto printed parts, 2510 fan hub already huge. any blocked path is pretty bad. 

  • Lost ability to use heatset insert, but now use a pair of m3 screws.

  • Optionally, the fan spacer is there to increase the space between the hub and the heatsink, removing dead spot a little, but also have the bottom lip to redirect the air just a little up instead of fully blowing onto the sock - effect should be very small but not point not to include it.

    • In my testing, it seems to redirect the air up just fine, not blowing below the heatsink.

    • The spacer REALLY help with fan noise if you're using a higher RPM fan like I do. Cut the whining very much.

    • This is sadly not comparable with the stock grill because fan sits so far out. I would design a grill to work with it but I haven't - also, this add back weight, so.

    • Also since it moves the fan out of the toolhead - flat to the front face, it very much less likely to pull in hot air from below and inside near the hotend. 

BOMs:

  • 2x 12/15mm m3 screws fan mounting, preferrably longer than 12mm. and longer if using the optional duck.

Print settings:

  • I stick with voron settings here.

Let me know if anything broken or whatsoever. I am measuring this based on actual part and CAD, printed in BBL ABS-GF and Fusrock ABS-GF with no shrinkage applied.

Tagi