UFO ambient lamp (WLED)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This model of UFO lamp with WLED cotrolled leds
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 221
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a mode of UFO LED lamp with WLED installed on EPS32
It's important to print "Beam" and "LED deflector" with WHITE PLA in spiral vase mode with only one wall
To built it you also need some M3 bolts and nuts, also a few hot inserts for M3 bolts
to make it light you need also LED Strip
I used WS2812B RGB LED Light Strip Pixel Strips 5M 5V 5050 300 (60LED/m)
UFO Lamp has 4 LED segmetns:
In base
In beam (around pole)
In UFO rould section
Top section
But it's up to you.
You also need ESP32 controller . I used ESP32 Nodemcu Development Board for ESP32 NodeMCU Module USB C 2.4GHz WLAN WiFi Bluetooth CH340 Chip
Then you need to install WLED from https://install.wled.me/
I attached "floating people" inside beam with termo glue
After printing i painted it with a spray paint
To power it you need basic phone charger or 5v over USB