Shelf for Tonie figures
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shelf for arranging the tonie figures. The shelf is hung in the loft bed With Fusion360/Step-File
- Ocena
- 0 / 5
- Polubienia
- 43
- Pobrania
- 95
- Wydruki
- 0
- Wyświetlenia
- 2422
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Action Figures & Statues
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My daughter's countless tonies needed a permanent place. I had found a good place for the tonies on my daughter's loft bed. The basic idea was a shelf to hang up. The aim was to accommodate as many Tonies as possible with the shortest possible printing time.
To achieve this goal, the parts of the shelf should be as flat as possible. To do this, I separated the shelf and holder into different parts. At the same time, the parts should be created in just one print job on the Ender 3v2.
As a counterpart to the magnets on the Tonie figures, I used M4 body washers. These are inserted during printing. In order to pause the print job at the right point, I used the color change function in Prusaslicer.
Here are my printing parameters:
- Layer height 0,2mm
- “color change” at Layer 1,8mm
- extrusion width 0.6mm
- Nozzle 0,4mm
- Infill 15%
- Material PLA
Assembly
For the assembly you need eight screws M3x16 and nuts M3
When the shelf is full…
When the shelf is full and space allows, you can then print the extension
To connect the extension to the shelf, replace the M3x16 screws with M3x20