Threaded Spool Hub
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made the threads with this http://www.thingiverse.com/thing:193647 . I like to keep these hubs on my spools for easy…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 74
- Wydruki
- 0
- Wyświetlenia
- 476
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
I made the threads with this http://www.thingiverse.com/thing:193647 . I like to keep these hubs on my spools for easy switching of filaments and it fits most of the spools i use including the cardboard ones. For very narrow spools you may need to trim some threads off by slicing a portion off the top of the bolt portion using 3d builder or other software or just by stopping the
print. I like the look of the bearings whether needed or not , and I usually buy extras or salvage them from roller blades
Print Settings
Printer:
p802M
Rafts:
No
Supports:
Doesn't Matter
Resolution:
.24
Infill:
I used 15%
Notes:
.printed with .24mm layer height, 15% infill, with or without support . If you print in ABS use support, as it doesn't bridge as well as PLA
You may use a drill or reamer to clear for a 8mm or 5/16 pin, rod or dowel. Snap in 2 608 bearings for a free wheeling spool or don't clear out the inner diameter so there is some resistance.
How I Designed This
I made the threads with this http://www.thingiverse.com/thing:193647 and used sketchup for the rest
Many Thanks to Mike_Mattala for NUT JOB | Nut, Bolt, Washer and Threaded Rod Factory
Category: 3D Printer Accessories