Bracket for Makita DUB182 mini blower (multiboard rail/multipoint mounted)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bracket holds the DUB182, fix to wall or whatever with multiboard rails
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 96
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This thing is really awkward to hang, the bracket supports the main body avoiding overmoulded parts.
It does require glue to fix the cradle to the 2 brackets, you may as well glue the 2 bracket parts together as well. The glue isn't load bearing, just stops it falling off when you lift up the blower. I printed in PETG and used superglue (CA) some people say adhesion is bad (especially without prep), some say it's fine. You do you.
Print as oriented, whatever settings you like, I think I did 4 walls because more plastic is more good. 0.06mm clearance between the key joined parts was good for me, if that doesn't work for you maybe just hit it harder until they mesh or snap. Apologies if you break your print.
Mount with whatever multiboard rail or multipoint you like, or the 75mm one I've included here which takes 8G countersunk screws. They do end up a bit proud of the surface but don't interfere with sliding on the mount for me.
If you're in Australia check out Siddament, he does tool brand coloured filament, and is also a madlad.
I realise when uploading the photo with the blower mounted you can't actually see the bracket. Trust me it is in the background holding it up, I did not put this much effort into creating an elaborate ruse.