ARO 2000 Filter / Regulator Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bracket to mount an ARO 2000 filter / regulator.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 19
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
Filament
My shop is air conditioned, so I was lazy and used PLA. If yours is outside or your shop isn't conditioned, I would strongly recommend a more thermally stable material such as:
PETG
ABS
ASA
Print Settings
Infill: 20% (this is what I tried. We'll see how it handles vibration).
Layer Height: 0.2mm
Supports: Not a one
Hardware
Item | Units | Quantity |
|---|---|---|
M4x20 | mm | 4 |
1/2 | inches | 1 |
Back story
(or “the part the recipe sites always put first but should leave until the end”)
I previously through together a metal bracket for this. It was a crap design and led to all sorts of vibration and clanging. Boo.
I lived with this blight for a few years. Then I decided to move the compressor. While moving it, I realized I should probably perform this thing called “maintenance.” There was no way I was going to put the “bang-bracket-3000” back on there, so something better was needed.
Upon closer examination of the filter, I found that it had a rather slick mounting arrangement. Fortunately I was able to procure a CAD model for this filter / regulator series and used that instead of having to take a bunch of dodgy measurements.
Am I proud of the interlocking pin mechanism? Yes. Yes I am.
Did I assemble and reassemble this about a million times because I found the close fit so rewarding? Also yes.