1 / 5
Magnetic Air Filter Holder for 115x115x20 mm filter — zdjęcie 1
1 / 5

Magnetic Air Filter Holder for 115x115x20 mm filter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is designed to hold an air filter onto a surface with magnets.

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
27
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Public Domain

This model was designed to fit an Elegoo Centauri Carbon 2 filter, but can hold anything up to 115x115x20 mm as long as it's not too small. I chose this filter because it is close to the size of the Makerbot Sketch air filter, which is very difficult to find. Since I couldn't find a source for a reasonable price, I designed it myself in TinkerCAD. It uses 10x3 mm disk magnets that fit into insets on the base. The cover fits smoothly, but if you want it more snug you can place a strip of duct tape along the inner faces between the base and the cover. Placed properly on the build plate, only minimal supports are needed for the magnet inserts, if that.5+6

Tagi