Magnetic Air Filter Holder for 115x115x20 mm filter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is designed to hold an air filter onto a surface with magnets.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 27
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Public Domain
This model was designed to fit an Elegoo Centauri Carbon 2 filter, but can hold anything up to 115x115x20 mm as long as it's not too small. I chose this filter because it is close to the size of the Makerbot Sketch air filter, which is very difficult to find. Since I couldn't find a source for a reasonable price, I designed it myself in TinkerCAD. It uses 10x3 mm disk magnets that fit into insets on the base. The cover fits smoothly, but if you want it more snug you can place a strip of duct tape along the inner faces between the base and the cover. Placed properly on the build plate, only minimal supports are needed for the magnet inserts, if that.5+6