1 / 1
*adjustable* Reolink Video Doorbell PoE - OpenSCAD Source - 35° Angled Wall Mount – 0° / 5° Down Tilt — zdjęcie 1

*adjustable* Reolink Video Doorbell PoE - OpenSCAD Source - 35° Angled Wall Mount – 0° / 5° Down Tilt

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Wall mount compatible with Reolink Video Doorbell PoE, editable OpenSCAD source. Includes 35° sideways versions nor tilt

Ocena
0 / 5
Polubienia
2
Pobrania
38
Wydruki
0
Wyświetlenia
127
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
CERN Open Hardware Licence Version 2 - Strongly Reciprocal

Reolink Video Doorbell PoE compatible angled wall mount - adjustable OpenSCAD Source

This is a parametric double-wedge mount for positioning a Reolink Video Doorbell PoE at a strong sideways angle.

Two ready-to-print versions are included:

  • 35° side angle / 0° vertical tilt

  • 35° side angle / 5° downward tilt

Geometry

The doorbell-facing surface measures 132.7 × 47.6 mm.

The six mounting points are arranged in a true rectangular layout:

  • 75 mm between the two blind screw holes

  • 30 mm between the two support pins on each side

  • Each blind screw hole is located exactly halfway between its two support pins

  • Blind hole diameter: 2.5 mm

  • Blind hole depth: 15 mm

The model also includes:

  • A large central opening for cables

  • Two side slots

  • Access pockets for screws and tools

  • Four small locating/support pins

  • A flat rear surface for printing directly on the build plate

Included files

  • reolink-doorbell-wedge-35deg-side-0deg-down.stl

  • reolink-doorbell-wedge-35deg-side-5deg-down.stl

  • reolink-doorbell-wedge-parametric.scad

The OpenSCAD source is included and can be adjusted using the following parameters:

side_angle = +35;
down_angle = +5;
(and more)

Negative values reverse the corresponding direction.

Recommended print settings

  • Print with the flat wall side on the build plate

  • 0.4 mm nozzle

  • 0.20 mm layer height

  • 4 wall loops

  • 5 top layers

  • 5 bottom layers

  • 20–25% gyroid or cubic infill

  • No supports required

PLA is suitable for test fitting. For permanent outdoor installation, ASA is recommended.

The 2.5 mm holes are blind holes for screws directly into the plastic. They are not intended for heat-set inserts. Do not overtighten the screws.

Compatibility

Designed for the Reolink Video Doorbell PoE used for this project.

Compatibility with other Reolink Video Doorbell versions has not been verified. Please compare the dimensions and mounting points before printing.

This is an independent design and is not an official Reolink product or accessory.

Tagi