Case for Mkomfy 1.5G
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
By request from a friend I made this so he wouldnt need to buy a new stove top guard
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 9
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
So my friend contacted CTM Lyng about getting the 3d models for the case, which they refused to hand out. So I made this to save him from unnecessarily buying a whole new system. This was designed in Inventor 2026, so I included both the step and ipt files
This should fit an older CTM Lyng Mkomfy 1.5G, depicted in this manual: https://ctmlyng.no/wp-content/uploads/2025/10/Bruksanvisning_6251680-1327-1448_1.5.pdf
The backplate is just blank, holes would need to be drilled if it is to be mounted with screws, or you could use double-sided tape.
Preferably this would be printed in ABS or better, PLA creeps at a too low temperature, PETG might be fine but remember that steam likely would make it creep. Might even be an issue with ABS, time will tell.