Case for Mkomfy 1.5G
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
By request from a friend I made this so he wouldnt need to buy a new stove top guard
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 9
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
So my friend contacted CTM Lyng about getting the 3d models for the case, which they refused to hand out. So I made this to save him from unnecessarily buying a whole new system. This was designed in Inventor 2026, so I included both the step and ipt files
This should fit an older CTM Lyng Mkomfy 1.5G, depicted in this manual: https://ctmlyng.no/wp-content/uploads/2025/10/Bruksanvisning_6251680-1327-1448_1.5.pdf
The backplate is just blank, holes would need to be drilled if it is to be mounted with screws, or you could use double-sided tape.
Preferably this would be printed in ABS or better, PLA creeps at a too low temperature, PETG might be fine but remember that steam likely would make it creep. Might even be an issue with ABS, time will tell.