Flasforge AD5M Stand Drawer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fully printable stand for the AD5M (and possibly AD5X) printer with storage drawer.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 249
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a stand with a drawer for the AD5M from Flashforge. It may also fit the AD5X and other printers but I don't have one to test for sure. This is for the drawer only, the main body will be uploaded separately for simplicity. All components are printable on the AD5M, although some of the flat panels can be replaced with flat material (5mm plywood, acrylic, etc) if you would prefer. The four side panels will need glued together, for this I prefer 5 minute epoxy. The flat panels have holes to insert pieces of filament to help tie them together, but after printing and assembling I don't think it's necessary. I have included files for basic feet that I printed out of tpu to help with vibration (feet are necessary for screw clearance on the bottom) and are simply glued to the bottom corners. Everything else is designed to be held together with 4-20x1/2" thread forming screws (link below). The main side panels can be printed two per plate but I preferred to split them up to minimize waste in the event of a failure. All other main stand panels need to be printed individually, standing on edge and diagonally across the plate due to length (I printed them all with a brim and did not have a single failure). The drawer panels can be printed 2 or 3 to a plate, except for the front panel, which must be printed on it's own. I printed the main sides at 4 wall/top/bottom and 15% infill, All other panels at 3 walls. All parts were printed in PLA. There is also a PDF with full assembly instructions.
Since printing, I have made a few small final changes, I have not reprinted the unit, but I am confident they should only improve printability or function.
Drawer Front/bottom/back plates have been narrowed by 1mm to increase clearance.
Cutouts have been added to the main sides to access to the printer's handholds.
The cutout in the front top plate has been made lower to not block the FlashForge logo.
Holes were added to the drawer side and back plates to insert screws to hold the back of the drawer together.
One final note, if you download the individual files rather than the .3mf, you will have to split the drawer sides in your slicer as they are too long to print.
Thread forming screws: https://www.amazon.com/your-orders/pop?orderId=114-1446714-4760254&shipmentId=P74YJbwzS&lineItemId=jlpilxirqqprsups&packageId=1&asin=B00GDYYJY0&ref_=ppx_hzsearch_conn_dt_b_pop_1
5 Minute Epoxy: https://www.amazon.com/dp/B001Z3C3AG?ref=ppx_pop_dt_b_product_details&th=1
Main Stand: