UniFi U7 Pro Max Cooling Vent Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount that acts as a spacer between the metal mounting plate and the ceiling surface.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 108
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Ceiling Spacer Mount for the UniFi U7 Pro Max
Germany, June '26. Heatwave. 🥵
With 40 °C outside, two things are essential: keeping your head cool, and keeping your WiFi alive. Both failed on me at times. My U7 Pro Max hit surface temperatures above 70 °C flush against the ceiling, and the connection started dropping out right when I needed it.
So I designed this.
What This Is
A spacer that sits between the metal mounting plate and the ceiling, lifting the whole assembly off the surface so the heat has somewhere to go.
- Screw holes for hardware up to M5
- Generous venting holes so warm air can escape instead of getting trapped
- Aligns with the existing plate, no drilling of new ceiling holes
Versions
There are two versions available as print profiles:
Version 1: Low Profile. Total height is 12mm. Cutouts are 12mm x 4mm
Version 2: High Profile. Total height is 16mm. Cutouts are 22mm x 8mm
I recommend going with version 2 for maximum ventilation effect.
A Note on the Holes
The mount is designed for A-holes.
(that's literally how the holes are marked on the metal plate. 😉)
Printing Notes
Print this in PETG or something even more heat-resistant. These access points still run seriously hot, even with the spacer doing its job. PLA will sag on you, and a drooping AP on the ceiling is not the look you want.
Stay cool, keep the packets flowing.