Extra large base for Modular 3D Printed Floor Lamp by GregDeanMann
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a larger base with space for electronics under the base, some venting, and an inset for the endcap.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 29
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Public Domain
This is a larger replacement base for the one provided with the paid design available here. In addition to the extra space there are support brackets and venting. A sacrificial support object is included if you're printing with PETG and PLA supports.
Note: The base has a 274mm diameter, so you'll need a larger printer.
Printing Instructions:
Don't add too many vertical shells, or this will impact the inset on the top object. I used the standard prusa structural settings with 50% infill to increase strength. You may want to add supports under the power supply port as well.
I strongly recommend avoiding PLA if you'll be storing a power supply or other electronics in the base.
I recommend setting vertical shell perimeters no higher than 2 - higher values may result in the top cutout getting bled into and the end-cap not fitting.
Related models:
You may also find the endcap reinforcement or T8 LED strip models helpful.