1 / 3
ReoLink RLN36 NVR + JetKVM 1U Rack Mount Brackets — zdjęcie 1
1 / 3

ReoLink RLN36 NVR + JetKVM 1U Rack Mount Brackets

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These brackets are to mount a ReoLink RLN36 NVR + 1x JetKVM + 1x Keystone Jack into a 19" rack

Ocena
0 / 5
Polubienia
1
Pobrania
18
Wydruki
0
Wyświetlenia
161
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I designed these brackets to mount a ReoLink RLN36 NVR into a 19" rack. I believe it will also work for RLN8 and RLN16 (the version with vertical vents on both sides). Please verify the model and version of your NVR before printing.

I used PETG to print these brackets. PLA would not hold up at all under the rotational torque of the rear heavy NVR.

Since the NVR is disproportionately weighted towards the rear, because of the drives, it requires some sort of rear support, which I was able to provide in my rack arrangement. Absent the support, the back of the NVR will experience some sagging. 

I bought some Fiberon Carbon Reinforced filament, to print stiffer brackets, however I have not had a chance to do so, yet.

You could flip the Left & Right brackets if you like using mirroring in CAD.

The following screw specs are what worked for me. Hopefully, your NVR components inside are the same size and arranged the same. Please VERIFY SCREW LENGTHS to make sure they don't interfere with any functional components inside the NVR.

You will need to pop off the cover to install 2x M3 10mm screws to securely attach each bracket to the cover with M3 hex nuts. Though the brackets did fine without these when I had left them off. 

You will also need to replace the cover retaining screws on each side, towards the front of the NVR, with M3 12mm screws.

To secure the JetKVM, you will need to replace the 2x M2 screws on top of the KVM with 2x M2 12mm screws inserted through the holes in the bracket.

Unfortunately, I mounted the NVR before I taking pics of the brackets by themselves. So, all I have here are pics of it in the equipment rack.

Tagi