1 / 11
Century Graphic Lens Board - ILEX No. 3 Shutter / Barrel (1.913" x 40 TPI) (2x3 Baby Graflex) — zdjęcie 1
1 / 11

Century Graphic Lens Board - ILEX No. 3 Shutter / Barrel (1.913" x 40 TPI) (2x3 Baby Graflex)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount an ILEX Acme No.3 Shutter or Barrel to a 2x3 Crown Graphic, Century Graphic or Baby Graphic.

Ocena
0 / 5
Polubienia
6
Pobrania
9
Wydruki
0
Wyświetlenia
118
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution

A 3D-printable lens board for mounting an Ilex No. 3 Shutter or Barrel on a Baby Graphic / 2¼ × 3¼ Graphic camera.

Two versions are included:

  • A board for the factory original four-hole Ilex mounting flange

  • A board with the Ilex No. 3 mounting thread (1.913" x 40 TPI) printed directly into the board

The flange-mounted version offers the durability of the original metal thread, while the integrated-thread version is useful when a factory flange is unavailable.

Because the Ilex No. 3 is unusually large for a Baby Graphic, users should verify clearance around the shutter controls, rear lens cell, bellows, and front standard before use.

Application Notes:
- Print in Black or Matte Black filament. The Orange and Gray boards in the photo are there to better illustrate only.
- Bellow draw. The baby graphic has a bellow draw of 7¾ inches, or about 196 mm.  That might limit the focal lengths you can actually use on this camera. 

Factory Flange Version V2
Updated August '26
- Easier to print, Print camera side DOWN. No support, 45 Degree Bridge Angle.
- Improved hole alignment.
- Tested with Sunlu Matte PLA.
- Before going out to buy mounting screws, you might be able to salvage self tapping screws from inexpensive disposable electronics you already have.

Factory Flange Version V1
- Tested with PLA and PETG
- Print camera side up. 
- Before going out to buy mounting screws, you might be able to salvage self tapping screws from inexpensive disposable electronics you already have.

Threaded Version:
- Print camera side up
- 0.15mm layer height. The 40 TPI thread needs this.
- Use scarf joints and randomize seam positions.
- Avoid crossing perimeters.
- 15% Gyroid infill.
- The threads already has +0.012 clearence over nominal baked-in. Should thread-on with minimal resistance. If it feels tight, you might be cross-threading or you material might have too much shrinkage.
- Tested with PLA and PETG (Overture PETG worked good, Sunlu PETG shrank too much and the thread become too tight.)

Tagi