1 / 8
Big agitator rod / stirrer to fit the Paterson Super System 4 rotary development tanks — zdjęcie 1
1 / 8

Big agitator rod / stirrer to fit the Paterson Super System 4 rotary development tanks

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Agitator rod, longer with more leverage to make developing film in rotary development tanks more pleasurable.

Ocena
0 / 5
Polubienia
3
Pobrania
21
Wydruki
0
Wyświetlenia
108
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Open Community License v1.1 + General Attribution v1

Hi

This is an alternative agitator rod for the Paterson Super System 4 rotary development tanks.

I have two issues with the original agitator rods:

  • They are so short you easily get photochemistry on your fingers if you're not careful when filling the tanks or the tanks are over filled.

  • I typically include abrupt changes in direction to introduce a little turbulance when agitating. The rod is too narrow with minimal leverage, if you do multiple rounds of development or use larger tanks your fingers can get tired / start hurting and its difficult to use enough force to shake the reels enough to dislodge air bubbles.

With the new rod, your fingers are further from the chemicals, not inside the tank, and you have more leverage so you need less effort to agitate and can easily whip the reels back and forth to remove bubbles.

Agitating larger five and eight reel tanks requires much less effort.

Features

Wider knob to provide more leverage/grip

Chamfered slot opening to self align a bit easier

Longer shaft to avoid getting your fingers wet

Open to suggestions for improvements.

Printing Instructions

Orientation

This was intended to be printed vertically with the widest section at the bottom with no supports.

Print Settings Used
  • Material: Prusament PLA

  • 0.4mm Nozzle with 0.2mm Structural Preset

  • Variable layer height

  • Perimeters: 4

  • Infill (not important): Gyroid 15%

I sadly did not have any red filament to make the top red when printing these.

Versions

I created a second version with rounded over edges, the first version is more grippy so I kept it.

Version 1

(Green photos)

Version 1.1

(Orange photos)

Change

Smoother corners, less grippy but more comfortable

Deeper channels and more sloped face to engage more easily

Support the original manufacturer by purchasing from them: https://patersonphotographic.com/shop/

(I have no relationship with them and do not benefit from you using the link)

Tagi