Inmotion V9 Kickstand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Broke your last stand? Just want another one for the front of your V9? Print this.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 117
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
This is a stand / kickstand for the Inmotion V9 Electric Unicycle [EUC]. I took a scan of the original kickstand using photogrammetry, cleaned it up a little, and made some cuts to make it look a little better that are inspired from another design. Can be installed on front or rear.
Print settings
Minimum 4 walls (0.4mm nozzle, so 1.6mm of walls)
Minimum 20% infill
5 bottom and top layers
[Recommended] Enable Alternate Extra Wall (Orcaslicer) for infill to better connect to outer walls.
Recommended filaments
TPU-GF 67D, HT-PLA, HT-PLA-GF, PC, PC-CF, PC-GF, PCTG, PET-CF, PET-GF, Any filled Nylons (PA-6, PA12, glass, nylon), ABS, ABS-CF, ABS-GF, ASA, ASA-GF, ASA-CF.
Please note that PETG isn't listed because it's not a good filament for nearly any real-world use case. Use at your own risk. PETG Pro is slightly better if you really want to print with it.