IKEA Rod Holder Set — RÄCKA / BOTAREN / HUGAD (glue & screw, support-free, 18–28 mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Top-mount rest holders that stop IKEA RÄCKA / BOTAREN / HUGAD rods (and dowels) from rolling. Glue & screw, 6 sizes, sup
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 36
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A tiny, clean holder that keeps a horizontal rod from rolling. Drop it on top of a wardrobe, cabinet or shelf and rest your rod in the closed ring — it wraps the rod fully so it can't pop up, and the flat base gives a solid glue or screw footprint.
This is a top-mount rest — it sits on a horizontal surface and stops the rod rolling. It is not a load-bearing wall mount. Need to carry weight off a vertical wall or panel? It pairs perfectly with a wall-mounted, load-bearing bracket such as Timo's Heavy-Duty Closet Rod Brackets (https://makerworld.com/en/models/2575037): use his on the wall, these on top of the cabinet, and the whole rod is supported.
Designed parametrically in OpenSCAD and pre-oriented so the bore prints vertically = no supports, no stringy overhangs, clean round hole.
Sized to real IKEA rods (plus common dowels):
18 mm — generic dowel / thin rod
19 mm — RÄCKA curtain rod
22 mm — BOTAREN shower rod (thin end)
23 mm — BOTAREN shower rod (mid)
25 mm — BOTAREN shower rod (thick end)
28 mm — HUGAD curtain rod
Bore has +0.4 mm radial clearance (loose rest). Need another size? The parametric rod_holder.scad is included — change one number.
Two mounts: Glue (minimal flush base, CA-glue on) and Screw (wider base, two M4 / wood-screw holes).
Included: 12 STLs (glue + screw × 18/19/22/23/25/28 mm), one bulk 3MF with all 12 as separate objects, and rod_holder.scad. Print-oriented → no supports.
Print settings: 0.2 mm layer, 3 walls, 15–25% infill, NO supports, any PLA/PETG. Files are already laid flat — don't rotate. Add a brim only if a corner lifts.
Use: print the size matching your rod, glue or screw the base to the top of your cabinet/shelf, rest the rod in the ring. Two holders per rod is usually enough.
