Pastamatic 9 Tooth Spindle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Reduced the gear ratio so the leadscrew takes 10% longer to reverse directions
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 111
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was using SunLu V3 Spools and i would notice that the leadscrew would reverse directions before the winding was finished so i reduced the gear ratio by 10% so that the leadscrew had more time to spool in a single direction
I've also included a bushing for the SunLu v3 spools it helps center the spool over the leadscrew (you can see it in the image with the gray filament on the receiving spool)
Print Settings
Filament Type: PETG
Layer Height: 0.1
Perimeters: Honestly i maxed it out and made it i typed in 20 perimeters, this takes forever to print so i didn't want to chance it snapping for whatever reason.
NOTE: ALWAYS spool your rolls TWICE you never want the inside of your roll to be on the outside!