FS2026 rewinding spool holder with original lid (Kichly)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
minimalist remix of FS2026 system to use the original cereal box lid (Kichly)
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 375
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- GNU General Public License v2.0
Overview
I really liked the rewinding mechanism on the fs2026 dry box system, but didn't want to use so much filament to print out a new lid. I also already had a desiccant and hydrometer holder in the bottom of my cereal box containers, so I didn't want to print new ones either.
This is a minimalist remix that lets me just use the rewinding shaft mechanism without the extra lid, holders, etc.
Design is loosely inspired by this hanging spool holder below, which is what I was using before (remixed to the cereal box brand I was using).
Cereal box (important!)
I'm not using the cereal box in the original fs2026 system. The one I'm using here is from a brand called Kichly, which happened to be a couple dollars cheaper on amazon when I bought them. The dimensions are slightly different, and this will (likely) not fit the Skroam/Praki/Wildone cereal boxes used by the original.
Other changes
The remix is compatible with the original rewinder, but I also included an optional remixed version with a couple changes
Shaft is slightly longer at the ends to fit cereal box dimensions better
Added clips at end of the support arms to grip on to the shaft better so it won't fall out easily
The original threads around the nut and interface did not fit together well, so I remodelled that
tighter tolerance for bearing at end of interface (next to nut)
The other rewinder files were not modified, but still included here for convenience.
Assembly
Note that support is not necessary for printing
The arms click into the top loop similar to the original fs2026 design.
While the top loop can hold on with just friction fit, you can (and should) also put some clear plastic tape so that it remains in place with the lid. I found this to be a much better experience overall for minimal effort
Take out the gasket seal in the lid
Wrap tape around the loop (see photo below) with the sticky side facing down
Fit the loop into the inside of the lid. Should fit relatively tightly.

Press the tape into the inside of the gasket holder. Make sure it follows the walls instead of leaving a gap at the bottom.

Press the gasket back into place

The finished look:

Other components
In my current storage containers, I also have a desiccant holder:
and this to pass the filament through: