1 / 5
Kitchen Aid mixer attachment hanger (screw in, no glue) — zdjęcie 1
1 / 5

Kitchen Aid mixer attachment hanger (screw in, no glue)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of DownRight's KA attachment hanger. 1. Wedge, to prevent pins rotating 2. Split for smal build plates

Ocena
0 / 5
Polubienia
2
Pobrania
21
Wydruki
0
Wyświetlenia
77
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial

A remix of DownRight's Kichen Aid stand mixer attachment hanger.

1. Split the 4-piece hanger into 2 so it fits on smaller build plates.
2. Screw holes moved to a better orientation. (If you're using tapered wood screws.)
3. Added a wedge on the poles and holes so the pieces don't rotate -- no glue required.

Slicing recommendations:
Slice the pin at 95% scale and the plate and pole at 100%. This was my first time remixing, and tolerances were a bit tight.

Printing recommendations:
Filament: PETG or PLA.
Layer height: 0.15mm - 0.25mm.

My print settings were:
PETG, 0.15mm layer height. I printed in 0.15mm for smooth curve on the pin, but honestly it was not necessary.

Tagi