Classic Mini Seat Lockdown Handle Grommet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement grommet for the lockdown handle on the side of Classic Mini Seats
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 26
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The seats in a Classic Mini have a pull handle for unlocking the seat to give access to the rear of the car. There is a grommet which covers where the handle exits through the side of the base, available as part number CZH2730.
These original parts are no longer available in most markets and the plastic becomes fragile and brittle, meaning you're likely to break them when re-trimming your seats, so I made these replacements.
Rather than a spring tab that the originals use, these a retaining clip to hold the grommet in place, which allows installation by just removing the handle.
These were designed to fit the single post headrest seats (pre-SPI) but they should fit other models of seat which used the same original part.