1 / 3
Nerf Demolisher 2-in-1 Rear Picatinny Rail — zdjęcie 1
1 / 3

Nerf Demolisher 2-in-1 Rear Picatinny Rail

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Nerf Demolisher 2-in-1 Rear Picatinny Rail

Ocena
0 / 5
Polubienia
14
Pobrania
9
Wydruki
0
Wyświetlenia
85
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Description:
Nerf Demolisher 2-in-1 Rear Picatinny Rail

Materials:
1x M3 Nut
1x M3x16mm Pan Head Screw
1x M3x25mm Screw

Printing Instructions:
Use supports necessary. I recommend PETG with 5 walls and 25% gyroid infill, but PLA should be fine.

Installation Instructions:
1. Remove the back top screws from the blaster. These will be replaced.
2. Insert the M3 nut into the slot on the bottom of the rail.
3. Thread the M3x25 pan head screw until it just barely does not come through.
4. Snap the back of the rail over the rear screw hole on the blaster.
5. Screw the M3x16 into tha back hole. It should thread into the blaster body.
6. Finish threading the M3x25 screw into the blaster. It will likely not reach the blaster, but should keep the rail in place.

Tagi