Nerf Demolisher 2-in-1 Rear Picatinny Rail
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Nerf Demolisher 2-in-1 Rear Picatinny Rail
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 9
- Makes
- 0
- Views
- 85
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Description:
Nerf Demolisher 2-in-1 Rear Picatinny Rail
Materials:
1x M3 Nut
1x M3x16mm Pan Head Screw
1x M3x25mm Screw
Printing Instructions:
Use supports necessary. I recommend PETG with 5 walls and 25% gyroid infill, but PLA should be fine.
Installation Instructions:
1. Remove the back top screws from the blaster. These will be replaced.
2. Insert the M3 nut into the slot on the bottom of the rail.
3. Thread the M3x25 pan head screw until it just barely does not come through.
4. Snap the back of the rail over the rear screw hole on the blaster.
5. Screw the M3x16 into tha back hole. It should thread into the blaster body.
6. Finish threading the M3x25 screw into the blaster. It will likely not reach the blaster, but should keep the rail in place.