SimpleHuman Dispenser Lid

I made this model a couple years ago for my SimpleHuman Dispenser because the lid would always break if you accidentally dropped them, which resulted in you having to buy a 15 dollar replacement, which is just outright ridiculous for a simple piece of plastic, let alone having to buy it outside of the US.

I recommend printing the model upside down because it can be hard to remove all the plastic supports at the bottom. 

PLA is a nice option. Transparent; even better. If not White PLA is fine. Never tried with any other materials. PETG might work nicely though.

Supports: Yes(Print model upside down, Only on build plate)

Rafts: Not needed(Unless you have adhesion problems.)

Print settings: Preferably slow, and nice layer height, ≤.20mm if possible.

Infill: 10%. Any higher is unnecessary and wasteful.

Theres also a "Soap" variant which I made but can sometimes make the print a bit harder to make. Sometimes using the normal, word-less variant is the better choice.

NOTE: The original brand lid has a seal which prevents water from entering into the dispenser's contents. This lid is NOT water-tight and may let small amounts inside if sprayed directly with water unless you seal it on your own.