Cable Routing for NEMA 17 Stepper Motors
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple mount for routing the hotend cables with cable ties, mounts to NEMA 17 stepper motor.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 446
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I had been wanting to clean up the cables on my Ender 3 Pro so I decided to make a simple cable routing support that mounts to the NEMA 17 extruder stepper motor.
For the MicroSwiss direct drive setup, the stepper needs to be removed to slip the lower bracket under, but it's a simple process.
#4-40 hardware was used to clamp the upper and lower brackets. I did have to ream the screw holes a little to keep the screws from threading into the plastic, but I just used a small screwdriver to do so.
Printed in PETG with 0.2mm layers.