1 / 4
Servo Powered Crossbow Filament Cutter Contact Point E3NG — zdjęcie 1
1 / 4

Servo Powered Crossbow Filament Cutter Contact Point E3NG

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows you to use the crossbow Filament Cutter in your E3NG without losing print area

Ocena
0 / 5
Polubienia
4
Pobrania
3
Wydruki
0
Wyświetlenia
208
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a followup and upgrade to my original Mod. You will need parts of it

Using a strong Servo allows you to use the crossbow filament cutter without losing print area or risking hitting it mid print.

BEWARE though, you'll have to connect it yourself, as well as make your own "piston", according to your setup i use stronger XY-Brackets, which are wider, so my distances are different from yours



BOM

  • Miuzei 20KG Servo

  • 4x M4 Heat Set Inserts

  • M5 T-nut

  • M5 Screw

  • 4x M4x10mm

  • Cable and Connector to connect the servo to your board

  • You need to make your own "Piston" (the metal bar i screwed to the servo!)

Config

[servo CutterAnschlag]
pin: P2.0
maximum_servo_angle: 270
minimum_pulse_width: 0.0005
maximum_pulse_width:0.002500
initial_angle: 0

Tagi