1 / 3
Housing for Nocemcu and HC-SR04 ultrasonic distance sensor — zdjęcie 1
1 / 3

Housing for Nocemcu and HC-SR04 ultrasonic distance sensor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a housing for a NoceMCU v3 and an HC-SR04 ultrasonic distance sensor. The lid will stay on when held upside…

Ocena
0 / 5
Polubienia
25
Pobrania
390
Wydruki
0
Wyświetlenia
1739
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

This is a housing for a NoceMCU v3 and an HC-SR04 ultrasonic distance sensor. The lid will stay on when held upside down, but it's easy to remove. I designed this together with my son as an introduction to 3D modeling.

Print Settings

 

Rafts: 

No

Supports:

No

Resolution: 

0.2 mm

Infill:

25%


 

Notes:

 

I printed a previous version of this in PLA. The big round holes in the wall came out quite nicely without supports, with some cooling. Since that print, I added a hole for the USB cable and some suports for the HC-SR04 sensor.

Please note that there's not enough room to plug cables onto the HC-SR04's connectors, but it will work if you bend the pins a bit. Alternatively you can just solder the wires on. It's also designed for a NodeMCU without pin header, or with the pins sticking up, whichever you prefer.

Tagi