Housing for Nocemcu and HC-SR04 ultrasonic distance sensor
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a housing for a NoceMCU v3 and an HC-SR04 ultrasonic distance sensor. The lid will stay on when held upside…
- Rating
- 0 / 5
- Likes
- 25
- Downloads
- 390
- Makes
- 0
- Views
- 1,739
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
This is a housing for a NoceMCU v3 and an HC-SR04 ultrasonic distance sensor. The lid will stay on when held upside down, but it's easy to remove. I designed this together with my son as an introduction to 3D modeling.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Infill:
25%
Notes:
I printed a previous version of this in PLA. The big round holes in the wall came out quite nicely without supports, with some cooling. Since that print, I added a hole for the USB cable and some suports for the HC-SR04 sensor.
Please note that there's not enough room to plug cables onto the HC-SR04's connectors, but it will work if you bend the pins a bit. Alternatively you can just solder the wires on. It's also designed for a NodeMCU without pin header, or with the pins sticking up, whichever you prefer.