Raspberry Pi 5 Dashcam with GPS
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case to utilize the Raspberry Pi 5 as a dashcam with GPS.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 2
- Wydruki
- 1
- Wyświetlenia
- 64
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
A purpose-built enclosure for turning a Raspberry Pi 5 into a compact, mountable dashcam. Designed for continuous recording of GPS-tagged video, this case integrates a camera module, GPS receiver, and a small onboard OLED-display into a functional housing.
Software
The software to run this dashcam will be available open source and on GitHub soon. Feel free to check it out, fork it, report issues, or contribute improvements. Setup instructions and dependencies will be documented in the repository's README.
Hardware
1x SD card
1x Raspberry Pi 5
1x Camera Module 3
1x 8 cm CSI camera cable
1x Waveshare LC29H (AA)
1x 128 x 128 px OLED display
1x 12 x 12 mm momentary switch
1x 1/4-20 threaded insert
6x Female to female jumper wires
13x M2 x 2.5 x 3.2 threaded inserts
It's recommended to print this case in PETG, as interior temperatures under a windshield can exceed 60–70°C in direct sun. PLA will soften and deform under these conditions.
For clean results, print with supports enabled and a 30-degree overhang threshold, because some of the side ports have overhanging geometry that will otherwise print in mid-air without support.
Assembly
Coming soon.