1 / 7
DeWalt 20V Max Battery to Chinese made Tool Adapter. (Temu bought) — zdjęcie 1
1 / 7

DeWalt 20V Max Battery to Chinese made Tool Adapter. (Temu bought)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The Chinese tool batteries do not last long (1.3AH). This adapter lets me use a larger capacity DeWalt battery.

Ocena
0 / 5
Polubienia
2
Pobrania
13
Wydruki
0
Wyświetlenia
129
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

Print release clip on side for strength and the body upright with supports. I used generic PLA with basic settings. Use a 3mm socket head cap screw and nut to mount release clip to the body. Use two 4mm socket head cap screws for back cover. For the DeWalt blade connectors I used 3/16 female connectors that I flattened down. The male connectors are about 0.5 to 0.6mm thick while the flattened female connectors are about 1.1mm and make a better connection to the DeWalt battery. The tool side connectors, I bought from Amazon.  (50 PCS Fuse Box Terminal Connector Auto Insurance Meter BX2091C). I have pictured two of the Chinese batteries for reference. One is for a handheld blower and the other a handheld mini chainsaw.

Assembly: Crimp and solder the flattened connector to the wires. I used 18AWG. Insert wires through holes on the DeWalt side until seated. Insert battery and push wires back toward the battery terminals until a good connection is achieved. Use a meter to check for voltage. Hot glue them in position. I put enough hot glue to reach the end of the cavity. In case they push in, they can only go as far as the cap block.

Crimp and solder the fuse block terminals on the other end of the wires. There is enough room for the terminal itself but not the crimp. Check polarity, positive and negative cross from one side to the other. Align the terminal in the slot and using a soldering iron push the crimp part into the plastic. Melt it in level with the top surface. Set wire down into the cavity and use two 4mm screws to thread the back plate onto the body end. Set the release clip into the top slot and use a 3mm screw and nut to secure the release clip. Finished and ready for testing. For me, it worked fine on the blower but on the chainsaw the fit was tight. A little sanding on the tool or adapter will help that.