1 / 7
DeWalt 20V Max Battery to Chinese made Tool Adapter. (Temu bought) — image 1
1 / 7

DeWalt 20V Max Battery to Chinese made Tool Adapter. (Temu bought)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

The Chinese tool batteries do not last long (1.3AH). This adapter lets me use a larger capacity DeWalt battery.

Rating
0 / 5
Likes
2
Downloads
13
Makes
0
Views
130
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial

Print release clip on side for strength and the body upright with supports. I used generic PLA with basic settings. Use a 3mm socket head cap screw and nut to mount release clip to the body. Use two 4mm socket head cap screws for back cover. For the DeWalt blade connectors I used 3/16 female connectors that I flattened down. The male connectors are about 0.5 to 0.6mm thick while the flattened female connectors are about 1.1mm and make a better connection to the DeWalt battery. The tool side connectors, I bought from Amazon.  (50 PCS Fuse Box Terminal Connector Auto Insurance Meter BX2091C). I have pictured two of the Chinese batteries for reference. One is for a handheld blower and the other a handheld mini chainsaw.

Assembly: Crimp and solder the flattened connector to the wires. I used 18AWG. Insert wires through holes on the DeWalt side until seated. Insert battery and push wires back toward the battery terminals until a good connection is achieved. Use a meter to check for voltage. Hot glue them in position. I put enough hot glue to reach the end of the cavity. In case they push in, they can only go as far as the cap block.

Crimp and solder the fuse block terminals on the other end of the wires. There is enough room for the terminal itself but not the crimp. Check polarity, positive and negative cross from one side to the other. Align the terminal in the slot and using a soldering iron push the crimp part into the plastic. Melt it in level with the top surface. Set wire down into the cavity and use two 4mm screws to thread the back plate onto the body end. Set the release clip into the top slot and use a 3mm screw and nut to secure the release clip. Finished and ready for testing. For me, it worked fine on the blower but on the chainsaw the fit was tight. A little sanding on the tool or adapter will help that.