Parametric Prusa Core One L Magnetic Sheet Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sheet holder that fits within the left side indentation of the Core One L held on with magnets & magnetic dust protector
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 22
- Wydruki
- 1
- Wyświetlenia
- 212
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Magnetic print sheet holder for left side of Prusa Core One L
REQUIREMENT
The side of the Core One L is non-magnetic, which is why this model relies on the use of an inside dust protector, with magnets on top of it. The dust protector is a remix of @dancan13f original model and can be found here:
Hardware
4 - 60mm x 10mm x 3mm magnets (2 for this model, 2 for the dust protector)
Can get the magnets here https://www.amazon.com/Powerful-Neodymium-Magnets-Rare-Earth-Magnet/dp/B07DFZH4WT
Print Settings
Rotate the model so the bottom is flat on the sheet.
Either PETG or PLA will work great.
Enable automatic supports (Supports should only be added in the magnet cutouts).
0.2mm layer height.
Add a Height range Modifier from 6mm to 22mm of 0.1mm. (Right-click model in Prusa slicer > Height range Modifier)
OR just print at a 0.1mm layer height for the whole model. (This will add about an hour to the print)
10% Gyroid infill
Photos printed with Prusament PETG Prusa Orange