Parametric Prusa Core One L Magnetic Sheet Holder
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€5.17 – €6.32 net (excluding VAT)
For file: 6 Sheet Holder Magnets(60 x 10 x 3).bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €5.75 excluding VAT (range midpoint).
- Weight reported by the author
- 103 g
- Print time reported by the author
- 4.59 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Sheet holder that fits within the left side indentation of the Core One L held on with magnets & magnetic dust protector
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 22
- Makes
- 1
- Views
- 228
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Magnetic print sheet holder for left side of Prusa Core One L
REQUIREMENT
The side of the Core One L is non-magnetic, which is why this model relies on the use of an inside dust protector, with magnets on top of it. The dust protector is a remix of @dancan13f original model and can be found here:
Hardware
4 - 60mm x 10mm x 3mm magnets (2 for this model, 2 for the dust protector)
Can get the magnets here https://www.amazon.com/Powerful-Neodymium-Magnets-Rare-Earth-Magnet/dp/B07DFZH4WT
Print Settings
Rotate the model so the bottom is flat on the sheet.
Either PETG or PLA will work great.
Enable automatic supports (Supports should only be added in the magnet cutouts).
0.2mm layer height.
Add a Height range Modifier from 6mm to 22mm of 0.1mm. (Right-click model in Prusa slicer > Height range Modifier)
OR just print at a 0.1mm layer height for the whole model. (This will add about an hour to the print)
10% Gyroid infill
Photos printed with Prusament PETG Prusa Orange