1 / 4
NexGen3D: Micro-Fit BMI Retainer for the BC-250 — zdjęcie 1
1 / 4

NexGen3D: Micro-Fit BMI Retainer for the BC-250

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple Micro-Fit Retainer

Ocena
5 / 5
Polubienia
40
Pobrania
414
Wydruki
1
Wyświetlenia
2752
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

I made this specific for the BC250 Micro-Fit connectors, as there was no way to lock them into place, and this also stops you from mixing them up, so you can connect all 6 pins on each without worry about crossing them over.

I made this specifically for my REDUX and PRO Cases and the custom plug and play cables I'm making, but I thought I would share for anyone to use in their projects.

Best to print from PETG as the locking tab needs to flex a little, and it uses the same M3 x 10mm or 12mm bolts that I use in my Case's, and the thread is modelled into the lower half.

Tagi