4S2P 32700 LiFePO4 Battery Pack For Amateur Radio
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fully 3D-printed frame for 8x 32700 LiFePO4 cells (4S2P).
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 139
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
DISCLAMER:
Building lithium battery packs carries real risk. Cells can short, vent, catch fire or cause serious injury and property damage if they are damaged, wired incorrectly, charged improperly or protected inadequately. Spot welding, soldering and handling live cells all add their own hazards.
This is a mechanical frame only. It is printed plastic. It provides no electrical protection of any kind, it is not fire rated, it is not certified or tested to any standard, and it does not replace a correctly specified and correctly wired BMS.
I am sharing this as a hobby project, exactly as I built it for myself. It comes with no warranty of any kind, express or implied, including fitness for any particular purpose. You are responsible for verifying that this design is appropriate for your cells, your BMS, your fasteners, your printer, your material and your intended use. You are responsible for your own wiring, your own welds, your own charging setup and your own safe handling.
By downloading, printing, modifying or building from these files you accept that you do so entirely at your own risk. I accept no liability for any damage, injury, loss or death arising from the use or misuse of these files or anything made from them.Hardware
All M3, self tapping into the plastic. 28 screws total.
BMS: https://www.aliexpress.com/item/1005009534278366.html
Print settings
Material: ABS, ASA or PETG. I printed mine in Creality Hyper ABS. PLA is fine for fit testing but I would not put it in a pack that might sit in a hot car
Images:
Welding


Assembled:

Finished:


Features
Cell seats with a retaining lip. The seats step down to a smaller opening at the outer face, so cells drop in from the inside and cannot fall through, while the terminal stays fully exposed for welding.
Spaced cells, not touching. A 3mm gap between cells leaves a plastic web, which is where the strip grooves live and where your welder probes need room.
Nickel strip grooves. Channels across every cell to cell web on both weld faces, cut to the depth of the retaining lip so the strip sits level with the terminal. Sized for 8mm strip by default.
