Adhesive Cable Clips for Swedish Installation Cables
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Parametric adhesive cable clips for Swedish installation cables, with tested EKK and multiple STL sizes.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 17
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Parametric snap-in cable clips designed for round Swedish installation cables.
The clips have a completely flat base intended for double-sided adhesive tape.
The cable is pressed through the top opening and held securely by the flexible clip body.
Important sizing information:
Cable type and conductor size do not always guarantee an exact outer diameter. Dimensions may vary between manufacturers and product generations. Always check the actual cable diameter before printing a large number of clips. The outer diameter is included in every STL filename so that the correct model can be selected by measurement.
- Material: PETG recommended
- Print orientation: Flat adhesive base on the build plate
- Supports: Not required
- Layer height: 0.20 mm
- Perimeters/walls: 4
- Infill: 30–40%
PETG is recommended because the clip arms need to flex when the cable is inserted. PLA may work, but it is generally stiffer and may become brittle over time.
Mounting: Clean the mounting surface before applying the double-sided tape. Use tape suitable for the surface, temperature and expected load.
Safety notice: This is a 3D-printed cable-management accessory and is not a certified electrical installation product. Verify that the mounting method and cable installation comply with applicable local electrical regulations. Do not rely on adhesive mounting where a detached cable could create a hazard.