"SPIRIT OF 3D" RIVER STEAMBOAT
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Approximately 0.8m long model of a steam-powered riverboat
- Ocena
- 5 / 5
- Polubienia
- 45
- Pobrania
- 167
- Wydruki
- 0
- Wyświetlenia
- 1033
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution
Set sail from the city of Philament for a river cruise on the "Spirit of 3D" steamboat.
This model, largely inspired by the real "Spirit of Peoria," is not particularly difficult in printing ad assembly.
To maintain good curvature of the decks and avoid damaging them with excessive supports, it is recommended to print these parts and the hull vertically to the print bed, using only a few organic supports at critical points.
For assembly, it's best to assemble the hull first, then the three C-shaped load-bearing structures to which the vertical walls and decks will then be attached. Railings, stairs, etc., should be assembled last.
Model printed entirely in PLA using 0.2 layers for larger pieces such as the hull and 0.15-0.1 for smaller pieces.