1 / 6
Cupholder for Electric Bike Company Front Basket - No-Hardware Zip-Tie Mount — zdjęcie 1
1 / 6

Cupholder for Electric Bike Company Front Basket - No-Hardware Zip-Tie Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Cupholder designed for the Electric Bike Company front wire basket - fits both the battery and no-battery versions

Ocena
0 / 5
Polubienia
0
Pobrania
4
Wydruki
0
Wyświetlenia
32
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Two printed parts, zero hardware. Zip ties and a dovetail-and-detent joint that clicks together and slides apart by hand for easy removal incase you need to remove it when locking your bike or when you don't need it. 

How it works
  • The mount bracket zip-ties to two horizontal basket bars (slots are sized for standard zip ties).

  • The cupholder's spine has a dovetail groove that slides down onto the bracket's rail. Two detent bumps click into matching dimples right as it seats, locking out rattle — no glue, no screws, no clips to break.

  • To remove: pull straight up. To reinstall: slide back on and it clicks.

Printing
  • No supports needed for either part.

  • Mount bracket: print flat on its back.

  • Cupholder: print ring-down.

  • Can print together

  • Print the bracket first and test the wire fit before committing to the cupholder, which is the much longer print.

  • Printed and tested in PLA.

Fit

Sized for this basket's mounting bars: 11mm wire diameter, ~46mm flat gap between the two bars, ~7.5° taper. Will not fit other baskets without modification.

Status: v0. Printed in PLA and confirmed working — good click-in fit, and it's held up on a real rides on the bike.

Tagi