1 / 5
Meshroom V2 - Dual 60mm Top Exhaust - Water-cooled — zdjęcie 1
1 / 5

Meshroom V2 - Dual 60mm Top Exhaust - Water-cooled

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A simple & sturdy mounting bracket for (2) 60mm exhaust fans, to help exhaust the secondary side rad in a Meshroom V2

Ocena
0 / 5
Polubienia
1
Pobrania
8
Wydruki
0
Wyświetlenia
137
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
GNU General Public License v2.0

I recently water-cooled my PC in a meshroom V2 in a dual rad setup and even with slim fans on the side rad the clearance between the GPU blocks and the slim fans wasn't great, it was definitely enough for air to flow and move but the slim fans would struggle on their own with their limited static pressure. Due to my other mod listed on my page, which allows me to securely mount the water blocked 5090 as low as possible, I have room about the fittings on the side radiators to install these fans and severely help the side radiator performance by exhausting all the hot air out of the top of the case instead of letting it stagnate. So I took some measurements and threw together this simple & sturdy mounting bracket for (2) 60mm exhaust fans, to help exhaust the secondary side rad in a Meshroom V2. I am able to fit 60mm Noctua's that are actually 25mm thick. I'm currently looking for replacement fans that are slightly stronger but these fans as is are working wonders. I've also included images of my loop temp to show the effect of these extra fans helping get all that hot air out immediately. 

Note that this only works with the case set up in 4-slot GPU mode though, this will not work with the case set up in 3-slot GPU mode.

You will need (6) M3 heat-set inserts and (6) M3x6 or M3x8 screws to secure the mount to the case. To get the mount in you can either flex it into place, it will bend GENTLY or you can remove one of the top side pieces of the case to get it in and then reinstall the side piece like you would when installing a large GPU. I used standard PC case screws to secure the fans to the mount itself. 

As always I have provided, STLs for those that just want to print and make it, and I've also provided the source CAD files (Solidworks) and STEP for those that want to tinker around with the files themselves.

Thank you for your interest in my page/models! Its greatly appreciated! 
-EddieSha 

Tagi